AIRTAC T1P CNC HI CAPA to MP5 HPA Adapter
AIRTAC T1P CNC HI CAPA to MP5 HPA Adapter
This CNC Aluminium HPA adapter lets you run CYMA MP5 mid-caps with your HI-CAPA pistol. Its heavy skeletonization, vivid anodization, and premium quality complement high-end builds.
BB Retention as standard.
The CNC magazine catch is easily reachable by both hands.
The adapter also comes in a T1P Soft Case for ultimate protection.
DO NOT EXCEED 150PSI WITH ANY AIRSOFT HPA ADAPTER.
ALWAYS USE AIR REGULATED BY A SECONDARY REGULATOR (e.g., AT200, WOLVERINE STORM, POLARSTAR MRS).
CHECK YOUR PSI BEFORE CONNECTING AIR TO A HPA ADAPTER.
NEVER CONNECT AIRTAC EQUIPMENT TO PAINTBALL AIR TANKS OR CO2 TANKS.
NEVER CONNECT AIRTAC EQUIPMENT TO A TIPPMAN STYLE HPA LINE
AIRTAC Adapters
Each of our adapters is designed to be low profile while reaching the field limit FPS. We design and manufacture all of our products to the highest standard, and do not charge extra for ‘premium’ features. Where applicable, this adapter features:- Lifetime Warranty (Our adapters have to be built to last)
- An injection moulded or CNC magwell that is impervious to BB strikes at point-blank skirmish FPS.
- CNC or Injection moulded Feed Tubes and Magazine Catches for lifelong durability.
- Tuneability/compatibility via integrated shim systems. Our adapters are designed to cope with 'airsoft tolerances.
- Gas Routers are injection moulded from NBR, 1:1 with the factory gas router.
MP5 HPA Adapter Info
- This magwell is made of CNC aluminum and cannot be damaged by BB strikes.
- Compatible with all CYMA MP5 Mid Caps (65 round metal, 120/130 round metal, Straight, Novritsch Straight, Bullet Window).
- BB Retention drops only 2 BBs when changing magazines
The feed tube shim fits under the feed tube. The rear shim is held in by two screws.
- Straight Magazines (Default Config) - Keep Shim In. Feed Tube spacer necessary on newer CYMA MP5 magazines
- Curved Long / Short Magazines - Remove rear shim. Keep the feed tube spacer in.
- If straight magazines will not feed with the rear shim and feed tube spacer installed, try removing the rear shim.
- In the very rare cases, short CYMA magazines do not fit your adapter, contact support@AIRTAC.me (they can solve this for you ASAP)
Key Information
- We use a US Foster Fitting as standard. This is the most common airsoft HPA fitting. EU fittings can be purchased separately.
- Some of our HPA adapters have a smaller internal volume than gas magazines. Because of this, you will need to use a PSI between 90 and 150.
- If you need higher FPS, you can:
- Fit a tighter barrel
- Use a longer barrel
- Use heavier BBs
- Fit an improved hop bucking
- If your replica has an NPAS fitted, we advise fully opening it.
- Do not exceed 150 PSI. Many airsoft guns will not see an increase in FPS past this, as the hammer may struggle to depress the valve correctly.
- Insert the HPA adapter with your bolt/slide locked back to minimize pressure against the nozzle loading arm.
This is a custom preorder item. By pre-ordering, you will have reserved and secured your item at a potentially lower price before it is released to the public. To cancel your preorder and receive an immediate refund, subject to a 5% fee, contact us directly. Due to circumstances such as CBSA customs inspections, factory delays and other situations out of our control. All ETAs (estimated time of arrival) are estimated to the best of our ability and are subject to change.
ETA 2-3 WEEKS
